DELTA 504208 Buffer tether shock absorber rope

DELTA NOSHOCK single small hook shock absorption belt 504208
Material: polyester fiber
Uses: aerial work, electricity, construction, outdoor sports, gardening, shipbuilding, installation industry
Style: Buffer type
Specification: 10 pieces, box
packaging: non-woven bag Packaging
product description:
Single head shock absorber belt, polyester fiber braided belt, 27 mm wide, equipped with 2 steel O-hook AM002. Length 1.8 meters, maximum unfolded length: 3.5 meters.
Material: polyester fiber
Instructions for use:
The user of this product must be in good health, professionally trained and have rich working experience at heights. The shock-absorbing belt is used in conjunction with the connector, one end is connected to the safety belt, and the other end is connected to the fixed point. The connector must comply with EN362 European standard. The total length of the shock-absorbing belt and safety hook should not exceed 2 meters. The fixed point should be located above the user, and the bearing capacity should be no less than 15KN. Before use, check the appearance of the shock-absorbing belt, interface, connector and other parts to ensure that the shock-absorbing belt is in good condition. Check whether there is any damage or breakage of the shock-absorbing belt, disconnection, sewing wear, rust and wear of the connector, etc. Do not use damaged or contaminated shock absorbers. Labor insurance equipment that has been dropped or questioned its quality during the inspection process must be returned to the technical service department. In the course of use, take corresponding arrangements to ensure that the shock absorber effectively protects against hazards (burning, splitting, chemical hazards, etc.) during work. The shock absorber needs to be inspected regularly by professionals, at least once a year. The product cannot be modified, replaced, repaired, etc. without permission.
Prohibited: It is
forbidden to use this product under circumstances other than those specified in the above instructions. Check carefully to ensure that the fixed point is above the user and in the event of a fall accident, the system can effectively prevent the user from falling or swinging left and right. Leave at least 6 meters of space below the fixed point. Make sure that you will not be obstructed during the fall. It is recommended to equip each user with a shock absorption belt.
Storage/transportation instructions: Store the
product in a cool, dry and ventilated place, avoid direct sunlight, keep away from fire and other heat sources, and avoid extremely cold and extremely hot environments and chemical erosion. The same applies to shock absorbers that become damp during use.
Stored in the original packaging for transportation. Care must be taken during transportation to avoid damage to the product.
Cleaning and maintenance:
clean with water and ordinary soap, and wipe the connector with a dry cloth. Do not use acidic and alkaline solutions for cleaning.
Performance:
The design, production and testing process of the product meet the requirements of European Directive 89/686 and EN355: 2002 European standard.